Quick tutorial on programming a jeenode micro
After spending too much time looking for ways to program a jeenode micro, I figured I’d put together a quick tutorial.
1. Wiring between Arduino, Jeenode Micro V3, and serial monitor
Uno 3.3V to Jeenode µ +3V
Uno GND to Jeenode µ GND
Uno PIN10 to Jeenode µ RESET
Uno PIN11 to Jeenode µ MOSI
Uno PIN12 to Jeenode µ MISO
Uno PIN13 to Jeenode µ SCK
Serial monitor RXD to Jeenode µ PA3 / AIO2
Serial monitor GRD to GRD
Serial monitor VCC to 5+V
2. Arduino IDE
a. open a new sketch
b. select jeenode µ board
c. select “arduino as ISP programmer”
d. select ACM0 port
e. click on burn boot loader
If you need to re-upload ISP to arduino, use “JeeArduinoISP” sketch
BASE SKETCHES being used for testing
– Receiver: w1receiverTemp
– Transmitter: w1senderPowerTempRotaryOpti
http://jeelabs.org/2013/03/21/programming-the-jn%C2%B5-at-last/index.html
